Remove Jammed Roll Paper

If roll paper jams, follow the steps below to remove jams.

• Watch the movie

1. Turn off printer.

   • Turning the Printer On and Off

2. Positioning your hands as shown, open roll paper cover.

   

3. Cut loaded roll paper with regular scissors or the like.

   Before cutting, loose the roll paper and lift it up.

   

   Caution

   • When cutting paper, be careful to avoid injury or damage to the printer.

4. Holding it at the positions indicated, close roll paper cover.

   

5. Push release lever back.

   

6. Remove jammed paper.

   • If paper is jammed inside the top cover

     1. Open top cover and move carriage to the left or right side manually, away from the jam.

        

        Important

        • Do not move the carriage over jammed paper. This may damage the print head.
        • Do not touch the linear scale (A) or carriage shaft (B). This may stain your hands and damage the printer.
          

     2. Remove any jammed paper inside top cover.

        After removing the paper, make sure there are no other scraps of paper in the printer.

     3. Close top cover.

        

   • If the paper from a roll is jammed by the paper feed slot

     Remove the jammed paper from the paper feed slot.

     After removing the paper, make sure there are no other scraps of paper in the printer.

     

   • If the paper is jammed by the ejection guide

     Remove the jammed paper from the output tray.

     After removing the paper, make sure there are no other scraps of paper in the printer.

     

7. Pull release lever forward.

   

Important

• Changing the release lever position while printing is in progress causes paper jam, misaligned lines, or wrong colors. Be careful not to touch the release lever while printing in progress.