skip to main text

Detecting Roll Paper was Replaced While the Power was Off

When you turn the printer on, it can confirm whether the roll paper was replaced while the power was off.

From Printer settings on the Home screen, set Auto feed at power on to Enable to detect the position of the roll paper's leading edge when the power is turned on. If the position of the roll paper's leading edge is over 1 mm since the last time the power was turned off, the printer determines that the roll paper has been replaced, and then starts feeding paper automatically to detect the paper width and the barcode for the management of unused roll paper.

Note

  • Setting Auto feed at power on to Enable causes the operations that can be done after turning on the power to take longer since the printer must detect the leading edge of the roll paper.

  • Auto feed at power on is set to Disable when you buy the printer.

Follow these steps to set Auto feed at power on to Enable as follows.

  1. Tap (Setup) on Home screen of operation panel.

    Note

    • If the Home screen does not appear, press the HOME button.

  2. Tap Printer settings.

  3. Tap Paper-related settings.

  4. Tap Auto feed at power on.

  5. Tap Enable.