Paper rubs against the printhead
- Check 1
Is the media type specified in the printer driver the same as the media type loaded in the printer?
Load paper of the same type as you have specified in the printer driver.
Loading the Upper Roll on the PrinterFollow the steps below to match the media type in the printer driver to the media type loaded in the printer.
-
To stop printing, press the Stop button.
-
Change the paper type in the printer driver and try printing again.
-
- Check 2
Is the paper loaded properly?
If not loaded properly, paper can buckle and rub against the print head.
Reload the paper.
- Check 3
Is the print head height set too low?
Set Paper Thickness (Head Height) in the touch screen menu to Auto.
- Check 4
Is the paper thick, or a type that curls easily or is prone to buckling after absorbing ink?
If using paper-based printing material such as Heavyweight Coated Paper, set Transport unit vacuum strength in the touch screen menu to Medium-strong or Strong. If that does not resolve the problem, increase the Paper Thickness (Head Height) setting in the touch screen menu.
Troubleshooting Paper Abrasion and Blurry ImagesIf using film-based printing material such as CAD Tracing Paper, set the Transport unit vacuum strength in the touch screen menu to Standard, Medium-strong, or Strong. If that does not resolve the problem, increase the Paper Thickness (Head Height) setting in the touch screen menu.
Troubleshooting Paper Abrasion and Blurry ImagesIf using paper thinner than 0.004 inches (0.1 mm), set Transport unit vacuum strength in the touch screen menu to Weak. If that does not resolve the problem, increase the Paper Thickness (Head Height) setting in the touch screen menu.
- Check 5
When loading paper in the printer, is the media loaded the same as the media type selected on the touch screen?
Select the correct media type in the touch screen menu when loading paper in the printer.
- Check 6
Does the paper have a strong curl at the front edge or is it buckled?
Set Cutting mode in the touch screen menu to User cut, and set leading edge detection to Do not detect.
To keep track of the amount of roll paper remaining in this situation, set Manage remaining roll amount to OFF before loading the roll paper, and then set Manage remaining roll amount back to ON after the roll paper is loaded.
